I understand Ameritron revised the TR relay board a number of years ago. I had an arc over ruin the original and now have a current replacement.
The board has at least seven w (wire holes). The obvious one I can do, coax for input and output, plus DC for relay switching.
However, it appears that is just part of the maze. I believe the sampling circuit for peak power is also piggy backed on same board.
In addition a few other wires of various color emerge from the chassis wiring harness.
The manual of course, is not in anyway detailed enough for me to wire in the new board.
So, does anyone have a photo, schematic or whatever, to aid in replacing the board. The output coax was installed very tight, and now I am thinking it advisable to just take it out and install a new run.
Thanks for any pointers on this rather simple on surface, but complicated in real life technical job.