I need help in setting up Rig Control using Ham Radio Deluxe and a Yaesu 1000MP.

Dick Clancey-KA1SM
rclancey@earthlink.net

Where can I get a wiring diagram for a TR  7950. I think
I reversed the polarity. There is power to the radio however it will not run.Is there a fuse inside the radio.

Dick KA1SM

In trying to connect my ICOM 756 Pro III to computer
control I get the following reading
Frequency=0,(a red x)
everything else checks alright and I can load PSK31.

In the past it worked.The CT17 and 756 have been sent to
ICOM to be checked and returned.

Any suggestions??

Dick Clancey-KA1SM

I am running Ham Radio Deluxe/ICOM CT17/Laptop. It has worked in the past.In the status window everything checks out other than Frequency which reads=0.
The com ports,and baud check with the radio.

I can not open PRO III in the laptop.

Any suggestions?

I have just purchased the above Amp and seem to have a problem making it work. I have tried both a Icom 756 Pro 3 and a Yaesu MP 1000.

The instruction manual is quite clear however I can not get any response on the grid and plate even though I have set the Load @ 5 1/2 and the Plate at 7 1/2 for 14.050
CW. The ALC setting in correct and I am putting in about 50 watts from the exciter.Needless to say the red LED lights up when I put it in operate and key it.

Needless to say there must be simple thing that I am over looking.

Any suggestions?

Dick