Hi. Does anyone know the pinouts for Yaesu rotors? (G-450)  When reading the directions, I was surprised not to see something about using heavier wire for the selenoid coil, like the T2X does.  Is it that the Yaesu doesnt brake in the same way? I have rotor cable with 2 heavier wires, and I would like to use them on the pins that draw the most current.

Thanks.
73, Bob N3RU
bobz@psu.edu

Hi. Does anyone know the pinouts for Yaesu rotors? (G-450)  When reading the directions, I was surprised not to see something about using heavier wire for the selenoid coil, like the T2X does.  Is it that the Yaesu doesnt brake in the same way? I have rotor cable with 2 heavier wires, and I would like to use them on the pins that draw the most current.

Thanks.
73, Bob N3RU
bobz@psu.edu

Hi.  I understand that a HAM-IV control box can be used with a Tailtwister rotor.  My question is- The HAM-IV control box has a 8-pin plug and the rotor has a 8 conductor terminal block.  How do the pins of the plug match up with the 8 wires from the rotor?  Do the pins just go straight across like the T2X control box with the terminal block, or does the plug use some other arrangement?

Thanks.

73, Bob N3RU
bobz@adelphia.net

I run a ham station at a Boy Scout Camp in eastern PA.  Someone
gave us a HAM-IV rotor box and I want to use it with a Tailtwister
rotor.  However, the HAM-IV control box has a 8 pin plug and the rotor
has a 8 conductor terminal block. How do the pins on the
HAM-IV box plug match up to the terminal block on the rotor?

Thanks.

73, Bob Zajko  N3RU
KB3BOY Trustee