Try Part # 1235S 1/8 in. thread or 1237S 1/4 in. Thread

73 Bob WD8ajy

Does anybody how to restring the the dial cord 

Thanks Bob WD8AJY

set every thing so you can get to the back of your equipment. makes it easier to hook up everything up or make changes.

Bob WD8AJY

This is the link

http://www.tesystems.com/comml-2-way-paging.htm

73 Bob WD8AJY

I found this at the TE web site under pager amps
                  IN            out      volts      amps                          Cost
1552RA    10-25    350    +13.8    54    UHF    CD/fn    1340

73 bob WD8AJY

Are all of the metal covers on the coils if they are try losing the nuts on the covers and re tighten the nuts. Corrosion on the covers can cause this problem.

The following statement is from the CCA web site.
 
Poor grounding of the RF coil shield cans may cause oscillations, particularly on 80 meters. This can be remedied by loosening the two nuts holding the shield cans and re tightening them. 73

Bob WD8ajy.

It might be setup for 6 meters.

There are a lot on EBAY but there in china.

The ones with a decimal point (.01) are microfarads the ones without the decimal point are picofarads.

Bob

The Swan WM-2000 uses 1N60s. Good chance yours does too.

73 Bob

why not use 12V then you will not need the resistor.

73 Bob.

here is another thing i had to do to a 32s3 on J2 the Rec xtal osc input there is a resistor r141 and a capacitor i disconnected the resistor from J2 this worked for me. 73 Bob 

I have an 32S3 that will not tune up unless the mic gain is all the way up. then i can turn it down to about the 10 o'clock position  on the air. 73 Bob.

try losing the screws and pull the to end plates together and tighten the two screws. 73 Wd8ajy 

check for shorts first. if there are none take a peace of small braid (i used some from very small coax) and solder it to the copper plate to the brass spring on the back of the cap. make sure it will not bind when the rotor moves. my email address is rlgooseberry@msn.com. 73 Bob