would chichen wire serve as an efective rf ground instead of using radials???

I want to put up a 5 band vertical, I read somewhere that chicken wire spread out under the antenna would be an effect ground instead of using radial wires??

I want to put up a 5 band vertical, I read somewhere that chicken wire spread out under the antenna would be an effect ground instead of using radial wires??

I have a tri band antenna on a 40 foot tower. I am thinking about erecting a 2 meter array on a seperate tower, how far apart should the antenna's(towers) be seperated?

I am looking for a manual and spec on the Henry, any suggestions. I tryed BAMA, no luck.

I need a manual for a KLM PA15-160BL I have searched the internet and had no luck.

I removed the case and found that the relay were not burnt, it was the plastic that seperated the relays. I don't think I burnt that part of the relay, Is there any way to test the relay? Should you be able to hear a click when the relay is activated?

Thanks for the info. This relay is a pull out and is in a plastic case. I can't figure out how to remove the case? Help.

I need a antenna relay for a TR3 that I just aquired. While trying to load the rig I was only able to get about 10 watts on my meter, and then I got smoke in the area of the relay, I pulled the relay and found it had a burnt area on the side. I don't know if I caused the burnt area or it was already there. Any help would be appreciated.

I have a Yaesu 620 B that the tech says some of the transisters are not available, It will only put out about 3 wats am. Anyone know where I can get parts for this rig?

I have just bought a rotor. On the bottom it says TRA-4, and DOO  50370-00. can anyone tell me what it is?

This is reply to several of you that responded to my orginal ? how to connect a Dentron GLA100 to my Kenwood TS 680.
My Kenwood show a connection with 12 volts that is supposed to key an amplifier.Someone said that I could make circuit to key the amplifier but then went on the say that if the amplifier uses 100-130 negative keying I can't use the circuit. Without keying the amplifier how am I to know what kind of voltage it requires? Would 12 volts that I have coming from my Kenwood key the amplifier. TNX for all your help.

I have a TS 680 no tune rig that I want to connect to a Dentron GLA 1000 , are these rigs compatible? and do I have to make any connection besides the coax?

I have a kenwood  ts680 which is a no tune rig. I have aquired a dentron gla1000 that I want to hook up.are these 2 rig compatable? and do I have to make any connection brsides the coax? TNX

I have a kenwood  ts680 which is a no tune rig. I have aquired a dentron gla1000 that I want to hook up.are these 2 rig compatable? and do I have to make any connection brsides the coax? TNX