Dale.
Thank you very much for taking time to answer me, i allready have a good antenna in the Quad ,but you know how we are,we allways want something better hi hi.
I will try and read more about it, i also spoke with Seymore W6CCP about it and he also spoke about an article he red.
So again thanks,i will not spend to much work on it, but fun trying/testing a little.
Torgeir  LA4UOA.

I have tried that T connector, and tuner, but result not very good,i think there must be another way to do this .
But thanks for answer.
Torgeir

Ihave two towers about 18m high, on one tower a 3 element stepp ir, on second tower a 4 element QUAD  from Cubex, both ant are 5 bands.
I had problems with the stepp ir therefor i bouhgt the quad,i have now fixed the stepp ir ,but not using it much.
I will try to connect both antennas together just for fun,not shure what i need to do that ? the distanse between the two tower/antennas about 50-60m.
(I am not going to stack them .)I know i may not win to much, but would be interesting trying it.
Any ideas how to do it ??

I need all help  i can get,so thank you very much again for your time with solving this problem,73 Torgeir LA4UOA.

I have been on holliday,so been away from my computer,thank you for answer,i will try what  you suggest,thank you.

S-meter will not read low signals,a station with s 4-6 reads as s zero on Orion 2, real strong signals lift the meter .Sub rx meter ok bandscoope also ok,with signal generator at 50 microvolt s-meter shows only about s-6-7.We tried to adjust up the meter with the  pot meter but did not help either.
Have done all resets, newest firmware got a new s-meter from Ten Tec,but no result.
And ,there are no ATT  or any RF GAIN ,no wrong settings done .
Ten Tec need the radio ,not any advice from them what problem could be,shipping cost from Norway to USA is very expencive,so try here for help first.
Radio rx is ok it is ONLY the s-meter reading that have a problem.I have red some Orion 2 owners have had problem with s-meter reading ,but with to high reading.
Sorry poor English.

Thanks again

Ok, i will look at it again, i only looked quick at it.
Thanks
Torgeir.

Thanks, yes i think it it will work, Telex still on marked,but they did not answer mail,poor service ? but think i will find out of it,the headset is not easy to open up to look inside it,but i find a way.
73 Torgeir.

Thank you for help.

73 de LA4UOA  Torgeir

Need manual/wiring diagram  for Telex CM-1320 Headset with mic.
Will try it on my Ten Tec Orion 2
Did e-mail Telex,but no answer from them.
Hope for help here.
LA4UOA Torgeir

a friend of mine wil take a look at it,i just try to get as much info as possible here in this forum, i am supriced that Ten Tec had no suggestion what it could be,or where to start looking for problems.

yes we will start with the generator ,have tried all kind of setting on the radio,but the meter just dont want to go up on normal reading,yes its made by man and things can go wrong.

did also check att and preamp

Itried  adjusting the rf gain, and also did a full master reset but still low reading ,and yes we will try to calibrate meter  again,i just dont understand how it could happen over night like that,we had no thunderstorm here or things like that either that night.