I'm not quite sure where my issue falls... so if I've put it in the wrong Category please forgive.
I purchased a Yaesu FT-450D today and upon arriving home went to set it up. Lo and behold, Yaesu does not provide RCA jacks for connecting to a linear amplifier which in my case is an Ameritron AL-80B. Rather, I had to purchase their part number T9207451 10-Pin Cable. On the other end of this are bare wires.
The cable is here: http://www.hamradio.com/detail.cfm?pid=H0-009117
The wiring is on Page 13 of the 450D Manual as downloadable from their Site. I wish I could post an image of the wiring diagram but am unable to. (Are there plans to add such a capability in the future?).
I lack the dexterity to solder these small wires and having said that I would gladly pay someone to do so.
Any takers? :-)