Using IC9100 with the ICOM RS-BA1 remote control software

[K7ERQ]

Fellow Hams. Ive been using an IC9100 with the new remote ICOM RS-BA1 over the internet. It works absolutely wonderful, 160 mtrs to 440 Mhz. ( I do have to set the antennas at the remote site.. my office)  But now, how do I turn off my Linear remotely, as I dont want it to run 24 x 7 ??

thanks in advance  roger palmer k7erq 1 801 372 2528

[AB4D]

Which amplifier are you using?

[K7ERQ]

Elecraft KPA500, I must set antennas on remote end, waiting for the new Palstar auto tuner

[NZ5E]

...But now, how do I turn off my Linear remotely, as I dont want it to run 24 x 7 ??...

Pasted from my QRZ page:

I have a Microbit 1216H Webswitch that I use to remotely control power to the HC-1.5KAT and also to trigger a Deltrol DPDT 240 volt relay to control power to the HL-1.5Kfx over the internet. I utilize a Vivotek IP7133 camera to monitor the front panels of the amplifier and antenna tuner over the internet.