Kantronics KPC3+ and Kenwood TM261a problem.

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : APRS : Kantronics KPC3+ and Kenwood TM261a problem.

Forum Help

1-2 of 2 messages

Page 1 of 1

Kantronics KPC3+ and Kenwood TM261a problem.	Reply
by N3QXX on April 6, 2005	Mail this to a friend!
Good day everyone! I have a problem with my TNC and my 2m rig. When the tnc xmits it is not keying the radio. It receives fine, just doesn't key the rig. I am pretty sure I have wired the connector up properly, but to be sure here is what I have. From the TNC to the RJ45: white to pin 3 (mic), red to pin 5 (stby/ptt) and black to to pin 6 (gnd). I have numbered the pins on the RJ45 with the tab up, pin one on right and eight on left if you were to look at the RJ45 directly, tab up. Anyone have any ideas or corrections to my wiring? Thanks and 73 to all. Christopher, N3QXX

RE: Kantronics KPC3+ and Kenwood TM261a problem.	Reply
by N6ZCT on July 9, 2005	Mail this to a friend!
i have the same problem using the wysis 7110 and tm 261.did you find the answer

Page 1 of 1

Next Topic: Axiom Sandpiper II GPS Engine
Previous Topic: FREE mobile GPS for APRS-- got a GM car w/ OnStar?

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$