440 Kenwood and Ameritron Al 811 - Amplifiers Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : Amplifiers : 440 Kenwood and Ameritron Al 811

Forum Help

1-2 of 2 messages

Page 1 of 1

440 Kenwood and Ameritron Al 811	Reply
by K4RVN on November 1, 2009	Mail this to a friend!
I am concerned that I may overdrive the 811 using my old 440 Kenwood. I plan to connect the ALC to the amp from the 440. I know of no reduced power setting for SSB other than the mic control. I can tune on cw reduced power with the carrier control I think. Anyone have any experience with this combination? Any info would be appreciated as my new amp should be here next week. Thanks, Frank

RE: 440 Kenwood and Ameritron Al 811	Reply
by K4RVN on November 8, 2009	Mail this to a friend!
I got the amp. Just for information, the method I thought would work with the 440 Kenwood did work just fine. I did connect the ALC from the transceiver to the amp and it does limit the drive with the amp ALC adjustment. I load on CW using the carrier control,and a watt meter. Then I switch to SSB and use the mic control.

Page 1 of 1

Next Topic: 756PRO and AL84 keying
Previous Topic: Amp Supply Parts

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$