Rigblaster Pro and Yeasu 897 - ComputersAndSoftware Forum at eHam.net

eHam.net Forum : ComputersAndSoftware : Rigblaster Pro and Yeasu 897

Forum Help

1-3 of 3 messages

Page 1 of 1

Rigblaster Pro and Yeasu 897	Reply
by KB1JFZ on September 29, 2008	Mail this to a friend!
Hello all, I searched the forums and the internet and can't seem to find any answers. First, let me say I should have read the reviews! Anyway, I just purchased a rigblaster pro to use with my yeasu 897. I have a desk top that is a few years old, but still top notch. I can't seem to find out how to hook them up and what software to run. I followed the instructions from western mountain. Not the best. All the "included software" was just a mishmash of stuff. I have never used any of it and am new to this aspect of ham radio. Anyone out there care to share how they have there system set up and what programs they are running to do what jobs. At the very least I would like to do CW, RTTY and rig control. Thanks! Dave

RE: Rigblaster Pro and Yeasu 897	Reply
by KD0BIK on September 29, 2008	Mail this to a friend!
I have your exact setup. Look up my callsign on QRZ and send me an email. 73, Jerry

Page 1 of 1

Next Topic: Com port problem "Can't open com port"
Previous Topic: Using Writelog for RTTY with a TS-2000

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.