Kenwood TS-430 - Elmers Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : Elmers : Kenwood TS-430

Forum Help

1-4 of 4 messages

Page 1 of 1

Kenwood TS-430	Reply
by KC4SJL on March 26, 2008	Mail this to a friend!
My Ts-430 tuning knob acts erratically.Have replaced encoder board but still wrong.Can tune from remote mic perfectly. Any tips? Thanks

RE: Kenwood TS-430	Reply
by VE7DQ on March 26, 2008	Mail this to a friend!
The ts-430's encoder requires adjustment with an oscilloscope to adjust the 'duty cycle' of the two phases generated by the encoder. The procedure is in the service manual, on page 42 in my original. If you have already performed this adjustment, I am unable to offer any other suggestions without more information. 73, Tom

RE: Kenwood TS-430	Reply
by KC4SJL on March 26, 2008	Mail this to a friend!
Thanks Tom, I will do the adjustments.I just replaced the unit without any adjustments. Carlos

RE: Kenwood TS-430	Reply
by NW5Y on March 27, 2008	Mail this to a friend!
Carlos, I have had similar issues with my 430S in the past. If you need some good advice shoot this guy an email http://www.amateur-repairs.com/index.htm. He is a nice guy and very helpful.

Page 1 of 1

Next Topic: Ft-747gx Transmit problem update
Previous Topic: gap eagle or steppir big IR

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$