TS 480 RX Audio Editor Function ? - Elmers Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : Elmers : TS 480 RX Audio Editor Function ?

Forum Help

1-5 of 5 messages

Page 1 of 1

TS 480 RX Audio Editor Function ?	Reply
by KE5OKQ on November 29, 2008	Mail this to a friend!
I have a Kenwood TS-480HX and use the ARCP 480 control. The Kenwood in-depth manual mentions use of the Audio Editor Function. How do I download and use the function? What does it do?

RE: TS 480 RX Audio Editor Function ?	Reply
by W6JAK on November 30, 2008	Mail this to a friend!
Hello, Check page 64 of the users manual (not In-Depth manual). Menu function 18 provides an equalizer for RX audio. I copied and pasted the section below. I have the TS-480SAT and it is fantastic. "RX DSP EQUALIZER EQUALIZING RECEIVING AUDIO Use Menu No. 18 to change the receiver frequency responses of the target signal. You can select one from 8 different receiver profiles including the default flat response. Selecting any of the following items from the Menu causes “RtEQ” to appear on the display. • Off (oFF): The flat frequency response (default). • High boost 1 (hb1): Emphasizes higher audio frequencies. • High boost 2 (hb2): Emphasizes higher audio frequencies but lower audio frequency attenuation is less than High boost1 (hb1). • Formant pass (FP): Improves clarity by suppressing audio frequencies outside the normal voice frequency range. • Bass boost 1 (bb1): Emphasizes lower audio frequencies. • Bass boost 2 (bb2): Emphasizes lower audio frequencies but higher audio frequency attenuation is less than Bass boost1 (bb1). • Conventional (c): Attenuates 2 kHz or more audio frequency slightly. • User (U): Reserved for the ARCP software. Off (flat) is programmed at the factory as a default." 73 Jack

RE: TS 480 RX Audio Editor Function ?	Reply
by W6JAK on November 30, 2008	Mail this to a friend!
After reading your question again, the answer is in the ARCP-480 software help file. "Click "MENU" in the Main window, or select "Radio" > "Menu..." in the Menu bar. The "MENU" window appears. Select one of the following equalizers. 18: DSP RX EQUALIZER 19: DSP TX EQUALIZER " The help file provides complete instructions on how to use the equalizer.

RE: TS 480 RX Audio Editor Function ?	Reply
by WA9UAA on November 30, 2008	Mail this to a friend!
Hi OM, The Audio Editor function is found under the pull down menu "DSP/ Filter". There is a section on examples and building your own. I have built and saved several CW filters of various widths and center frequencies. These are applied to the radio in the "User" choice of menu 18 for the receive audio. Hope this gets you started. 73, Rob WA9UAA

RE: TS 480 RX Audio Editor Function ?	Reply
by KE5OKQ on December 1, 2008	Mail this to a friend!
Rob (WA9UAA): Could you email me at ke5okq@yahoo.com? I have a bunch of questions.

Page 1 of 1

Next Topic: 2M section on the IC706MKIIG
Previous Topic: feet for radios...

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$