IC706MkIIG - Memory programming - Elmers Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : Elmers : IC706MkIIG - Memory programming

Forum Help

1-5 of 5 messages

Page 1 of 1

IC706MkIIG - Memory programming	Reply
by N5TWB on August 20, 2002	Mail this to a friend!
The operations manual is either written above my head or is just not clear on how to write a CTCSS code for repeater access into a memory channel. I have accessed the part of the menu to dial in the frequency of the tone code but it is not retained to memory and the FM-T mode does not show up. Please help me decipher the manual. Thanks....

RE: IC706MkIIG - Memory programming	Reply
by AC5E on August 20, 2002	Mail this to a friend!
Hi Bart: It's been several years since I played with a '706 but as best I remember you have to hold the memory write button down until it beeps. And that seemed to take half the night. 73 Pete Allen AC5E

RE: IC706MkIIG - Memory programming	Reply
by KD3V on August 20, 2002	Mail this to a friend!
assume we are setting VFO A (I have skipped getting around the menus) 1. Set the desired repeater freq. (assumes auto-DUP is set correctly for that freq.) 2. Set tone frequency (both encode and decode if you want decode) 3. (is this your missing step?) press the TONE button until you see the symbol in the upper right showing FM-T (or FM-TSQL if you want decode as well). 4. now select the memory of choice and 5. NOW press the MW key (it only takes about a 1 second press) Just setting the pl frequency does not make it get saved. You might have forgotten to select the PL mode which shows as -T or -TSQL next to the FM symbol. Hope this helps. If not then there is a ?broken? menu button that applies to the MW function or a real bug in the software. 73's KDa3Ve

RE: IC706MkIIG - Memory programming	Reply
by N5TWB on August 21, 2002	Mail this to a friend!
Thanks for these steps...they sound like what I need to do this evening. Other ideas/thoughts are still welcome.

RE: IC706MkIIG - Memory programming	Reply
by KD5TQH on August 21, 2002	Mail this to a friend!
Bart, thanks for asking this question. I also couldn't program the codes for my new 706. If you find any other steps that need to happen, please send me a message. 73 Dan KD5TQH

Page 1 of 1

Next Topic: Inverted Vee
Previous Topic: Critique this circuit

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$