PSK-31 Need an interface that can work wid an IC70

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : Elmers : PSK-31 Need an interface that can work wid an IC70

Forum Help

1-4 of 4 messages

Page 1 of 1

PSK-31 Need an interface that can work wid an IC70	Reply
by HP1AC on July 15, 2001	Mail this to a friend!
I can not key my IC706MKIIG with the interface I built . It is the one with a DB9 couple of 1n4148 -a 2N2222A a 10K resistor. Can copy fine in the screen using WINPSK31-se223 bu when hitting F12 . No transmission. I am feeding the rig thru the 13 pin acc.socket in the back. Any ideas?

RE: PSK-31 Need an interface that can work wid an	Reply
by VE7LFN on July 15, 2001	Mail this to a friend!
have you checked these webpages? http://packetradio.com/ http://www.w5bbr.com/soundbd.html Hope this helps.

RE: PSK-31 Need an interface that can work wid an	Reply
by KL7IPV on July 16, 2001	Mail this to a friend!
I use the RigBlaster with my IC-706 and it works great. See you on PSK31 73 Frank KL7IPV

RE: PSK-31 Need an interface that can work wid an	Reply
by AD6MJ on July 16, 2001	Mail this to a friend!
You might want to put an ohmeter on the leads you are using for PTT. It sounds as if either of 4 things is happening(or not happening): 1: The software is not configured to use PTT on the proper port. 2: Somehow you are on the wrong pin on the DB connector.(easy to do) 3: You are on the wrong pin of the connector on the radio. I'm not familiar with the 706, but most radios it is easy to get the wrong pin. 4: something is wrong with the interface. If your ohmeter goes to short whent the software tells it to, then the problem is on the rig end. If not it's either the interface, db connection or software config. Good luck and 73, Bill

Page 1 of 1

Next Topic: Icom 735 erratic Frequency Display
Previous Topic: 2950 mic wiring

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$