Oak Hills WM-1 Calibration - QRP Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : QRP : Oak Hills WM-1 Calibration

Forum Help

1-1 of 1 messages

Page 1 of 1

Oak Hills WM-1 Calibration	Reply
by AB9DF on September 28, 2003	Mail this to a friend!
I picked up a used QRP watt meter at Dayton this year but I have tried it out and I dont think it is calibrated correctly. Does anyone have a manual for this wattmeter that could share with me the steps for calibrating the device. I dont need the whole manual but just the steps to tweek it so that the wattage meter reads correctly. I think it takes just a DMM and a small screw driver. If anyone can help you can either respond here or email me at rknight@servicesupply.com Thanks Rob AB9DF

Page 1 of 1

Next Topic: 1/4 wave, 1/2 wave and random wire
Previous Topic: For the electrical engineers

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$