eHam.net - Amateur Radio (Ham Radio) Community

Call Search
     

New to Ham Radio?
My Profile

Community
Articles
Forums
News
Reviews
Friends Remembered
Strays
Survey Question

Operating
Contesting
DX Cluster Spots
Propagation

Resources
Calendar
Classifieds
Ham Exams
Ham Links
List Archives
News Articles
Product Reviews
QSL Managers

Site Info
eHam Help (FAQ)
Support the site
The eHam Team
Advertising Info
Vision Statement
About eHam.net


Reviews Categories | Amplifiers: RF Power - HF & HF+6M | Ameritron ALS-500-RC Help


Reviews Summary for Ameritron ALS-500-RC
Ameritron ALS-500-RC Reviews: 1 Average rating: 4.0/5 MSRP: $$49.95
Description: The Ameritron ALS-500RC is a remote control head for the
Ameritron ALS-500M amplifier with serial number 13049 and
above. (For ALS-500M units with a serial number below 13049,
you can purchase the ARF-500K remote kit to modify your ALS-
500M to use the ALS-500RC) The ALS-500RC allows the
amplifier to be located away from the operating station and
still have access of the amplifiers front panel controls.
The ALS-500RC operates the amplifiers power switch and
frequency select switch. The ALS-500RC has LEDs to indicate
power, transmit and overload. It also has a current meter.
Product is in production.
More info: http://www.ameritron.com/Product.php?productid=ALS-500RC
Email Subscription
You are not subscribed to this review.

Subscribe!
My Subscriptions
Subscriptions Help

You can write your own review of the Ameritron ALS-500-RC.

AA1IK Rating: 4/5 Aug 29, 2015 14:50 Send this review to a friend
Update on my last review to 'Good'   Time owned: 0 to 3 months
The ALS 500 RC is back in operation again. Apparently it is very sensitive to SWR. When the SWR is elevated, just a bit, the Amp will cut out. Shutting the ALS 500 RC off for a couple of seconds and then turning it back on resets the amp.

I noticed that the SWR changes a little bit while driving through town, not so much on a rural highway.

In order to get the lowest SWR possible for the given driving condition I use CW mode to send a steady signal out with the Amp off via the ALS RC. After the reflected power is noted as 'rock bottom', no needle movement at all on the SWR meter, I then turn the amp on and switch to SSB mode on the radio.

Adjusting the antenna ever so slightly, if the SWR is elevated after the amp is turned on insures the SWR is at 'Rock Bottom'! Sometimes it changes just a little, the difference between using 100 watts from the radio to tune the antenna and reading the SWR with the amp at 500 watts.

I called Ameritron for a fix. They said to adjust the pot on the PCB in the rear of the amp clockwise to reduce the SWR sensitivity. They said that using the RC unit increases SWR sensitivity of the amp.

I have not adjusted it yet, but pay very close attention to 'rock bottom' SWR with no needle movement in reflected power. If the AMP shuts down due to temporary elevated SWR, I'll adjust the pot as Ameritron suggested.

This has not been a problem since I'm paying very close attention to the SWR.

 


If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.