eHam.net - Amateur Radio (Ham Radio) Community

Call Search
     

New to Ham Radio?
My Profile

Community
Articles
Forums
News
Reviews
Friends Remembered
Strays
Survey Question

Operating
Contesting
DX Cluster Spots
Propagation

Resources
Calendar
Classifieds
Ham Exams
Ham Links
List Archives
News Articles
Product Reviews
QSL Managers

Site Info
eHam Help (FAQ)
Support the site
The eHam Team
Advertising Info
Vision Statement
About eHam.net


Reviews Categories | Receivers: Commercial/Military/Marine adaptable to ham use | Collins ARR-41 R648 Receiver Help


Reviews Summary for Collins ARR-41 R648 Receiver
Reviews: 2 Average rating: 5.0/5 MSRP: $unknown
Description: 190-550Hz & 2kHz to 25mHz receiver. Dual conversion above 4kHz. 2 RF and 3 IF stages with 6.1kHz and 1.4kHz mechanical filters at IF of 500kHz. Full time noise limiter (no off function) for AM & CW reception. Mechanical digital frequency readout and built-in crystal calibrator
Product is not in production.
More info: http://
Email Subscription
You are not subscribed to this review.

Subscribe!
My Subscriptions
Subscriptions Help

You can write your own review of the Collins ARR-41 R648 Receiver.

N8FVJ Rating: 5/5 Mar 19, 2017 20:12 Send this review to a friend
Great  Time owned: 6 to 12 months
Collins produced an ad for this receiver. They stated the R-648 was designed with many the 51J-4 design features. Unlike the 51j-4 the R-648 has a tunable RF front end with variable cores like the R-390 series. Using dual RF amplifier tubes and the tuned front-end it is unaffected by powerful shortwave stations and in band strong stations. Like the R-390 the R-648 may be the ultimate AM receiver.
 
N8FVJ Rating: 5/5 Mar 18, 2017 17:10 Send this review to a friend
Excellent Receiver  Time owned: 3 to 6 months
The Collins R-648 receiver is a Mil Spec built design for the US Air Force in 1956 thru guessing 1960. It has a tunable front-end like the Collins R-390 & R-390A and weighs about 35 lbs.

The receiver is very quiet on the ham bands. 75 meter AM kind of just pops out of the low noise with a strong signal. I can hear most ham AM stations and this is a better receiver than the great performing National NC-183D. Having double conversion, there are no 'ghost' signals on the shortwave bands.

Controls are limited compared to the ham receivers of past. However, the receiver works so well controls such as crystal phasing, Q Multipliers, Noise Limiters, etc are not needed. This receiver has a full time noise limiter and it does not cause any distortion. The RF gain is a screwdriver adjustable control under a spring cover. It is located on the front panel and could be converted to a knob control.

The receivers only used a 28 volt dynamotor supplying 250 volts DC at 100ma. Converting to 120 volts AC power supply requires DC on the tube filaments due to many electrolytic capacitors in the filament circuit. 26 volts AC with convert to 27 volts DC with standard rectifiers and a CRC filter having 2 ohms resistance. 20,000uF per caps makes less than .05 volts AC ripple. B+ is a simple design not needed to be mentioned here.

If you have a chance to buy one, I would spend the $500 to $600. Having 17 tubes, I is a powerful receiver.
 


If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.