- Amateur Radio (Ham Radio) Community

Call Search

New to Ham Radio?
My Profile

Friends Remembered
Survey Question

DX Cluster Spots

Ham Exams
Ham Links
List Archives
News Articles
Product Reviews
QSL Managers

Site Info
eHam Help (FAQ)
Support the site
The eHam Team
Advertising Info
Vision Statement

Reviews Categories | Antennas: HF: Vertical, Wire, Loop | ZeroFive Antennas Multiband Vertical Help

Reviews Summary for ZeroFive Antennas Multiband Vertical
ZeroFive Antennas  Multiband Vertical Reviews: 105 Average rating: 4.9/5 MSRP: $469.00
Description: A Multiband vertical for 10 to 160m,41 foot tall feed with your coax or ladder line,For use with a tuner,Made from 6063 t832 AL tubing,Requires radials,5kw cw,10kw ssb pwr handling,Freestanding,Comes with base insulator and tube.
Product is in production.
More info:
Email Subscription
You are not subscribed to this review.

My Subscriptions
Subscriptions Help

You can write your own review of the ZeroFive Antennas Multiband Vertical.

<— Page 2 of 11 —>

K9TWO Rating: 5/5 Jun 25, 2014 21:48 Send this review to a friend
Great  Time owned: more than 12 months
I had previously been using a homebrew 33 foot vertical strapped and insulated with white PVC tubing to a 4x4 post in the ground. It worked well but not enough length for 80 meters. I stay below 3.800 to stay away from the ex-CBers and their bad habits. I made my own base load out of a 20 foot piece of 1/4 inch copper tubing to get a closer match on 80. It now resonates at 3.5 mhz. This keeps the loss out of the feed line and the tuner. Electrically, the antenna is always grounded thru the base load coil to ground which consists of 3 ground rods bussed together and about 15 radials. The 43 foot antenna is built like a tank and easily laid down by one person. I am 68 years old and have no problems at all. I really like this antenna, very well built and can be assembled in 15 minutes without a manual.
Yes I use a homebrew UNUN at the base to keep RF off the coax. Also have 7 or 8 ferrite slugs on the coax right at the base load coil I made. It's all enclosed in a 12x12x6 PVC electrical box from Menards. The taps on the base load coil was easy to set up using my Comet CAA-500 analyzer.
I use 1.5 inch copper strap from the base load coil to the antenna and ground. The copper strapping is treated with anti-oxide compound because you can't connect copper to aluminum without problems. An SO-239 is mounted at the bottom of the box and I have a one inch length of white PVC to shield the SO-239 from rain. Will be glad to send picture of the box and plans if you would like You can get my email on QRZ. Still use my Palstar AT2KD tuner on some frequencies but without so much loss in the tuner and coax since it resonates at 3.5 mhz. Tuner is not in line when near 3.5 mhz.
No, this antenna won't work on 160 without huge losses unless you have a top hat or use it in an inverted L configuration. Your only kidding yourself trying. Of course I knew that before my purchase so am not blaming Zero Five. It's a great antenna.

Note: I recently added the 1:4 Unun and added 45 feet of wire to a nearby tree and converted it to an inverted L configuration. What a huge difference it made for DX And locals both. Worked G0EVY with 100 watts and Dave said I did not need an amp. The local 7160 group were all giving me great reports with the 100 watts. I can tune any frequency from 40 m thru 6m with the FTDX-3000 tuner and can tune 80 and 160 easily with my Palstar tuner smoothly. I use only about 30 feet of feed line and my antenna is only located about 15 feet from my station and my TV with no RF issues. Your mileage may vary. The 45 foot wire I added at the top is about 3 feet from the top under the hose clamp and use a 1/8 inch nylon
Line on the opposite side with a bungy cord to keep the antenna vertical. Can't even see the wire or nylon cord.

73 K9TWO Don Since 1959
KE2TR Rating: 5/5 May 3, 2014 17:49 Send this review to a friend
Outstanding  Time owned: 0 to 3 months
I purchased the Zero Five 43' vertical about 3 week ago, Tom had the antenna at my door three days later and man alive this antenna is built. Yes you need radials, a good Unun (use the Balun Design 4:1) plus a 8' ground rod and your set to go. Very easy to build and install and now that I have down 26 radials man this thing plays. I use it with a Palstar AT2KD and it makes for one sweet system, SWR on 20 is very close to 1.4 to 1, almost the same on 15&17 but 75,40 and 10 I use the tuner but its so broad banded that once tuned you can qsy over +-100Khz. One thing is for sure this antenna works the longer haul DX, its not the antenna for local rag chews but even on 75m it does a good job of working EU early and late during a band openings. I have up two loops at 70' which work well but this vertical does better on the longer haul contacts. Recommended for lots of fun working DX.
KENWOODUSER Rating: 5/5 Mar 7, 2014 09:48 Send this review to a friend
Great choice for an aesthetic, unguyed, multiband vertical  Time owned: 6 to 12 months
This is a good antenna and I am very well pleased with it. Tom's support is good, as is the antenna quality. Price is ok.

My criteria going in was to have a very strong, unguyed, aesthetic, multiband vertical antenna. This antenna has proven to have all of those qualities. It is indeed unguyed and I have watched it in flex in sustained winds with gusts up to 70mph. I thought it would come down but after having seen that, I realized it is as strong as advertised and I forget about it in the strongest storms.

Because it is so strong, no guys are required. It makes for a very clean install, which I don't mind looking at, nor do the neighbors.

I have tuned it in the shack with the built-in autotuner on bands 80-10, although I mainly use the antenna for 40 meters. An remote base tuner should be used for best performance.

I installed about 1200sq ft of wire mesh under the antenna and overlayed the mesh with copper radial wires, which were bolted to the mesh. The mesh and radial wires are bolted to ground rods at the base of the antenna. The antenna is fed with over 100ft of LMR-400 direct bury cable, which passes through conduit back to the wall of the shack to a DXE panel, which houses a number of PolyPhaser surge arrestors.

The antenna performs well-enough for my liking. I recently busted a pileup and made a 10,000 mile contact with the antenna. I've also made local contacts with it. As a vertical, it is noisier than the hex beam next to it on the same site and A/B tests are very easy to perform. Overall, I am happy with the way it performs. I probably wouldn't be if I had not installed the radial field/screen. A remote base tuner will only add to its performance.

I would buy another one. In fact, I just may for another location.
G1PHK Rating: 5/5 Dec 6, 2013 12:51 Send this review to a friend
great antenna  Time owned: more than 12 months
we had 60 to 70 mph winds yesterday in the uk the wind did not change direction for hours, my 43ft vertical was bent double for hours, it finally came down, but this was no fault of the antenna it was the pipe supporting it which fractured, the antenna is lying in my garden absolutely flat, i`ve just knocked in a scaffold pole into the ground and will postcrete it in tomorrow and get this great antenna back on the bands
N8WGM Rating: 5/5 Dec 5, 2013 22:03 Send this review to a friend
Best vertical I've owned  Time owned: 0 to 3 months
I've had the 43 foot multiband vertical now for a few months and I can say that it is by far the best vertical antenna I've used.I've owned over 20 so far.

I needed a new vertical as the woods I live in does not physically allow for rotatable yagi's and I really do not want to deal with towers, wind, ice loading and all that. No traps was another requirement. I just wanted an antenna that can get me out on 80 through 10 meters while running 1kw power or a little more.

I contacted Tom (The owner of Zero Five) and we talked for a while. I was sold when I read all the reviews here on e-ham and my discussion with him.

The package arrived and it was small! I could not believe that a 43 foot antenna was packed in the box. Opening the box it was clear that this antenna is made very well. There are two stacks of antenna parts. To assemble, you take one from the fist stack and then one from the second. The stainless clamps are quality and the antenna goes together well. If you decide to get this antenna, make sure that you use a bit of Noalox anti oxidant. It will keep the joints free of oxidation and help with keeping the connections electrically viable.

I decided to buy the antenna from Tom and get the UnUn from DX engineering. They are not too far from me in Talmadge Ohio and so I bought the UN UN and the radial plate from them. Plus I was able to browse the Summit Racing store where DX engineering has their store which is always fun!

After putting everything together, I found that the receive on my Kenwood 930 came alive. Signals from all over the place on 10-160 meters. It is an excellent receive antenna. Best I have used so far. I put down 80 various length radials which are 14 gauge solid insulated wire. The coax is RG8U military spec Belden cable. It is partially buried and is over 25 years old. Still works great!

Transmitting on the Zero Five 43 footer was also a pleasant surprise. Much better than even my inverted V for 80 meters. I was able to contact several DX stations on 80 and it was like they were next door. I switched between the V and the vertical and I noticed a signal strength gain to stations in Europe with the vertical over the V on both receive and transmit. Japan was easy with this antenna also.

If you are looking for a great vertical antenna with no traps, give Tom a call at Zero Five. He knows antennas and will answer any questions you might have.

KE0Q Rating: 5/5 Oct 24, 2013 07:20 Send this review to a friend
Still Great!  Time owned: 6 to 12 months
I've now been using the Zero-Five 43 ft. vertical for about 6 months and couldn't be happier. I consistently work both domestic and DX contacts and receive good signal reports. I'm only using 100 watts with a Kenwood TS-590S. I have the optional MK II mod which has provided good performance on the higher bands, especially 17 meters.

There's no guy wires on my antenna and a few times we've experience fairly high winds here in Central Minnesota, but once the winds die down the antenna sits straight. The antenna is well made and once properly installed it is virtually maintenance free--no traps or coils to mess with. Tom not only makes a great product, he's a man who provides great customer service. I wouldn't hesitate to recommend this antenna to anyone, especially to those who have limit space and are unable to put a bunch of aluminum and copper wire in the air.
K3GO Rating: 5/5 Oct 23, 2013 19:48 Send this review to a friend
43foot muftiband vertical Amazing  Time owned: 0 to 3 months
Ordered from Tom the 43 foot without the Unun for $200 ( priced increased to 209) but excellent material and construction. Assembled in couple hours, great machining, mounted on pole in back yard, threw out 4 43 feet radials,installed transformer, hooked up 125 feet of coax and turned on KX3

Antenna is quiet and so tuned 20M and ran across CN2FA , worked on 2nd call with 5 watts ! Then dropped to 40 meters and second contact with RA6AN with one call answering his CQ . Rec. 579

I am totally impressed with this 43 foot antenna
Don't waste your time or money on any other brands and stay tuned as I am building the 80-160 loading AD5X matching network. Also plan to hook more radials up, bury the coax and see you all on the bands.

Oh I forgot to mention , I painted the vertical camouflaged flat and you cannot see it in the back yard!
This antenna fits in with my trees and pleases everyone !
I will be posting pictures and future additions to my new QTH

Tom is excellent to work with and I will be getting a second one to phase the with Array solutions phasing box.

Simple no traps and best bang for the buck...
73 de
W9OD Rating: 5/5 Aug 24, 2013 13:14 Send this review to a friend
Takes a licking and keeps on ticking  Time owned: more than 12 months
Last week, we had six tornadoes go through our neighborhood. Wind speeds were clocked at 80 to 110 MPH! My Zero Five 43 foot vertical with stood the beating with just a bit of a swag to it. These antennas are very well built! Mine is ground mounted with 40 fifty foot radials, I work all kinds of DX using power levels from 5 watts too about 800 watts, mostly low power. I highly recommend the Zero Five antennas. Tom also offers excellent costumer service.
W9JB Rating: 5/5 Jun 7, 2013 13:36 Send this review to a friend
Excellent Build Quality  Time owned: more than 12 months
Performance equally good, too. I have the 10-40 Meter GP, with "built in" radials/counterpoise. Mounted "sub-optimally" at about 2 feet off the ground in a cluster of pine trees. Fed with about 130 feet of buried high quality coax. Use a Ten Tec AutoTuner (not needed on all bands, however). With about 400 watts (via a Ten Tec Hercules II), I can usually work anything I hear on CW, and most everything on SSB. Durability outstanding. Will operate (via tuner) on 80 meters, but not as effective as my O-C-F on that band or 160 meters. Bottomline: excellent value and durability for the money.
N1EJH Rating: 5/5 Jun 7, 2013 11:02 Send this review to a friend
Big Dog 10-160 43 ft.  Time owned: more than 12 months
This an update to my first review. Owned mine for 10 years! It's been in constant use thru every storm New England could get hit with, she's still standing. Never any issues!!! Tom built mine with a non tilt over base that bolts to concrete base. I'll never part with it. If it should ever come down my first call will be to Tom. You can't buy a better monopole. It's funny as soon as Tom introduced his antenna line and they started to sell well two other companies intoduced theirs. Trust me they not even close to the build quality of a Zero-Five. Spend the extra ging and get the best their is.
<— Page 2 of 11 —>

If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.