Pages: [1]   Go Down

Author Topic: Need Help with HAMCap  (Read 134 times)

W2ECK

  • Member
  • Posts: 209
Need Help with HAMCap
« on: March 19, 2020, 12:59:17 PM »

Looking for some help or a steer to a forum that can help me get HamCap running again. Have v1.92. When I plug in a DX call, it computes the QTH lat/long but not the Chart or the map.  In the lower left hand corner there a rolling series of numbers, which if I mouse over says "computing". I haven't used in the last few weeks but previously it was working fine. Any ideas or recommendations on where to find help? I have DX Atlas and IonoProbe installed on the same Win10 PC.

73 Paul
w2eck
Logged

W2ECK

  • Member
  • Posts: 209
Re: Need Help with HAMCap
« Reply #1 on: March 24, 2020, 09:10:42 AM »

Well I guess no one uses HamCap or my question stumped the Panel  :)
I solved by finding all previous installs of Vocap and uninstalling from my win 10 pc. Then downloaded a fresh copy of Vocap (2018 version) and installing. HamCap is now working fine. BTW - good article in the lastest QST on HamCap.

73 Paul w2eck
Logged
Pages: [1]   Go Up