Pages: [1]   Go Down

Author Topic: Yaesu FT-818 + SCU-17 + Raspberry PI ?  (Read 129 times)

IW5CWC

  • Posts: 63
    • HomeURL
Yaesu FT-818 + SCU-17 + Raspberry PI ?
« on: December 15, 2021, 02:51:21 PM »

If Santa will bring me what I have been asking him for  ::) the goal is to setup a portable digital radio station with my FT-818 connected to a Raspberry PI 4 through the SCU-17 Yaesu interface.
However I saw that to make the SCU-17 to work under MS Windows it is needed to install a USB virtual com port driver before connecting the SCU-17 to the PC (at least the instructions from Yaesu say to follow this procedure up to Win 8, I presume the same applies also to later versions...).
I am wondering if something similar has to be done on the Raspberry and there is some driver to install before connecting the SCU-17, too or not.
I googled for that but didn't find very much. Can someone give directions for the above setup to work?
Thanks.
73
Logged

WO7R

  • Member
  • Posts: 6041
Re: Yaesu FT-818 + SCU-17 + Raspberry PI ?
« Reply #1 on: January 19, 2022, 04:56:00 PM »

I'd start here:

https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers

If you get the drivers to work (source code may be available for Raspbian recompiling or so says my quick-and-dirty look), then software on Linux can treat it like any other serial "TTY" style device.

The cabling appears to be a standard USB cable.  It's just a question of support for the particular chip used in the Yaesu rig.
Logged
Pages: [1]   Go Up