Print

[N1CX]

I'm a fairly new HRD user. I been trying to figure out why the azimuth is showing incorrectly from my qth. I put in FN42E but none of the AZ bearings line up to what I know to be true looking at spots. For instance a DL8 was just spotted and it shows the AZ as 8 degrees. DL is roughly 50 degrees from here. FY was just spotted and the az is shown as 75 degrees not the 149 it should be.

Someone must have seen this before. What am I doing wrong here?

[N1CX]

So if I open the rotor control and enter a call it shows proper azimuth in this window. But the spot window Az is showing completely incorrect. Same fn42e locator also.