Pages: [1]   Go Down

Author Topic: Kenwood tmv71a stuck in cross band reapeat  (Read 96 times)

KJ4SKP

  • Member
  • Posts: 106
Kenwood tmv71a stuck in cross band reapeat
« on: October 23, 2022, 11:36:49 AM »

hoping you guys can help. Was operating in cross band repeat yesterday and now my radio will not switch out of crossband repeat mode. I followed the procedures holding tone while turning the radio on, which should switch it out of crossband repeat mode. However it does not. The key pad is now locked can’t make any changes how can I reset my radio?
Logged

WM4RB

  • Member
  • Posts: 36
Re: Kenwood tmv71a stuck in cross band reapeat
« Reply #1 on: October 23, 2022, 12:29:01 PM »

https://www.manualsdir.com/manuals/162075/kenwood-tm-v71e-tm-v71a.html?page=95

Key Operation:
Turn the transceiver power OFF.
Press [F] + Power ON.
Rotate the Tuning control and select your desired reset type: VFO, PART, PM, or FULL.
Press the Tuning control to set the reset type. • A confirmation message appears on the display. ...
Press the Tuning control again to perform the reset.
Logged
Pages: [1]   Go Up