Pages: [1]   Go Down

Author Topic: Hotspot Setup Question on Startup host  (Read 132 times)

K7AAT

  • Member
  • Posts: 407
Hotspot Setup Question on Startup host
« on: March 04, 2023, 03:11:45 PM »

Have a Zumspot for many years which always worked on YSF reflectors with my Yaesu Fusion radios.  Recently I wanted to try to access a DMR TG so I'm trying to change my YSF Startup Host in my Yaesu System Fusion Configuration section  to start up in a DMR TG .   Here is what I have entered:

 YSF Startup Host:   YSF00002 - YSF2DMR
UPPER CASE host files is ON
WiresX Passthrough is  OFF
My DMR ID is properly entered
DMR Master :    Brandmeister_3103
My old HotSpot security password is entered
DMR TG:    3141

Can anyone advise why when I bring up the hotspot on the computer that it does not go directly to the TG specified?   I suspect I am misunderstanding how to do this but I've never done any hotspot work beyond Fusion only.  Thanks for any ideas.
 K7AAT
Logged

K4FMH

  • Member
  • Posts: 681
Re: Hotspot Setup Question on Startup host
« Reply #1 on: March 04, 2023, 05:29:39 PM »

Hi,

Did you save these settings before restarting?

Frank
K4FMH
Logged

K7AAT

  • Member
  • Posts: 407
Re: Hotspot Setup Question on Startup host
« Reply #2 on: March 04, 2023, 06:52:18 PM »

Hi,

Did you save these settings before restarting?

Frank
K4FMH

Yes, Frank.
Logged

K7AAT

  • Member
  • Posts: 407
Re: Hotspot Setup Question on Startup host
« Reply #3 on: March 05, 2023, 01:20:44 PM »

Further research -  I guess I cannot do what I wanted to do,  which was having my hotspot startup in YSF2DMR mode and go to a specific DMR TG ,   all on bootup.   Looks like at best I can setup startup to  the YSF2DMR room in YSF,  then  I will have to manually use my radio to command hotspot to connect to the specific DMR TG.    Either do this or just buy a DMR HT and access my hotspot with DMR instead of YSF.      If anyone can affirm this for me it would be appreciated.

K7AAT
Logged

N1YFA

  • Posts: 9
    • HomeURL
Re: Hotspot Setup Question on Startup host
« Reply #4 on: March 14, 2023, 01:31:50 PM »

That is interesting. I have a boomerang mini pi-star hotspot and only run DMR. I have tried every which way to cross from DMR to YSF to get into the UFB New England network here in Maine and it will not work what so ever. I have tried several different ways and its a no go. I know I know, I should just go out and get a Yaesu Fusion radio. With the price that they are at + I already have enough VHF/UHF radios of various sorts with limited room for coax/antenna that is already at its capacity + VHF is very quiet in Maine and UHF is almost non-existent, I don't want to waste more money on something that will get used once a week if that. I would rather just use what I already have sitting here. Sadly, the most I can get out of my setup is being able to hear UFB New England, but cannot get the DMR to cross back over with my voice. I wonder if Fusion and DMR are barely compatible if at all.
Logged
Pages: [1]   Go Up