Pages: [1]   Go Down

Author Topic: Oak Hills WM-1 Calibration  (Read 2764 times)

AB9DF

  • Member
  • Posts: 101
Oak Hills WM-1 Calibration
« on: September 28, 2003, 11:01:49 AM »

I picked up a used QRP watt meter at Dayton this year but I have tried it out and I dont think it is calibrated correctly.  Does anyone have a manual for this wattmeter that could share with me the steps for calibrating the device.  I dont need the whole manual but just the steps to tweek it so that the wattage meter reads correctly.  I think it takes just a DMM and a small screw driver.  If anyone can help you can either respond here or email me at rknight@servicesupply.com  

Thanks Rob AB9DF
Logged
Pages: [1]   Go Up