eHam

eHam Forums => Boat Anchors => Topic started by: AB1MN on June 07, 2019, 05:16:17 PM



Title: Central Electronics 100v/200v Dial Cord
Post by: AB1MN on June 07, 2019, 05:16:17 PM
Hi all,

Bit of a long shot, but does anyone have instructions/diagram for the stringing of the dial cord on the Central Electronics 100v/200v transmitters? This is the cord that moves the red pointer across the frequency drum.

This looks like it should be an interesting project what with the phasing method of sideband generation and the broadband final stage (no PA Tune and Load controls). Still in the cleaning phase so a long way to go before worrying about alignment and all that.

Thanks,

Bob


Title: RE: Central Electronics 100v/200v Dial Cord
Post by: WA4JQS on June 08, 2019, 08:04:05 PM
Service and User Manual Central Electronics - 100V -- Download ...
https://www.lost-manuals.com/equipment.php?id=15788
Service and User Manual -- Central Electronics -- 100V. Manual Type: Service and User Manual, CentralElectronics-9104-Manual-Page-1-Picture. Pages: 88.

this may help 73 Tony WA4JQS


Title: RE: Central Electronics 100v/200v Dial Cord
Post by: KM1H on July 10, 2019, 09:25:19 AM
When in doubt read the manual.

Ive had my 100V since 1965, and dial cord still OK but it sure looks easier than the chain drive on my NC-300!

Carl