- Amateur Radio (Ham Radio) Community

Call Search

New to Ham Radio?
My Profile

Friends Remembered
Survey Question

DX Cluster Spots

Ham Exams
Ham Links
List Archives
News Articles
Product Reviews
QSL Managers

Site Info
eHam Help (FAQ)
Support the site
The eHam Team
Advertising Info
Vision Statement

Reviews Categories | Tools & Test Equipment for the amateur radio work bench | REK TSG-17 RF Signal Generator Help

Reviews Summary for REK TSG-17 RF Signal Generator
REK TSG-17 RF Signal Generator Reviews: 2 Average rating: 0.5/5 MSRP: $100.00~145.00
Description: High Frequency RF Signal Generator 100KHz-150MHz from 6 bands.
Product is in production.
More info: http://found on ebay
Email Subscription
You are not subscribed to this review.

My Subscriptions
Subscriptions Help

You can write your own review of the REK TSG-17 RF Signal Generator.

K6MA Rating: 0/5 Aug 24, 2015 15:40 Send this review to a friend
not working  Time owned: more than 12 months
I purchased one of these in 2014 and did not use it. Today I needed to use it and found out it has no output. Starting at the 110volt input it goes through a transformer to the "ON" switch. Even the LED power light switch does not work. I am unable to find a schematic for this. The workmanship is the worst I have ever seen, huge blobs of solder on the one-sided circuit board. Total waste of money.
If I could remember who I purchased it from I would try to send it back but since it has been over a year I probably will be out of luck. Lesson learned here; if you purchase something over the internet test it immediately you get it.
N4ZAW Rating: 1/5 Aug 19, 2011 07:14 Send this review to a friend
Not ready for prime time!  Time owned: more than 12 months

This is marketed as a "Precision RF Signal Generator which can generate high frequency from 100KHz - 150MHz. With it's 3rd harmonic on range 'F', 450MHz can be reached. Because it has output terminal for AF and the modulating frequency can be adjusted from 150Hz to 1.5KHz, the RF signal generator can fulfill most requirement of hobbyist, service station, production and technical instruction".
Uh.... Right! Set on the 10-30MHz scale, this thing drifts-down 1MHz (not Kilo...MEGA) in less than 5 minutes! It does slow it's migration down to something tolerable after about one hour or so, but never stops. But just try to adjust it! If you get within 2 feet of the tuning knobs it effects the frequency.Tuning is also extremely touchy! Note that no shematic has been released for this T.O.O.B. iether. Upon opening it up, the lack of assemblly QC is apparent, with sloppy component placement, lead trimming, and solder joints my 10 year old grandson would reject -- this is inexcusable in a so-called "precision" diagnostic device.
It really is a shame too, because it has so much potential. I learned thru performing the needed modifications that it can be transformed into a functional signal generator with a little assembly re-work, adding three actual KNOBS, (as opposed to those useless screw slots it comes with),the addition of a frequency counter,additional shielding around the tuning cap and a 10-turn pot for fine-tuning.
The drift-down is still an issue I have yet to find a cure for, but in the meantime, save you money for a good SG. And keep in-mind the old addage, "you get what you pay for!"
This POC is no "bargain" as presently-produced!

If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.