Manager


Manager - NA4M
Manager Notes

Reviews For: Ventenna VT-27 2M/440 Dual Band

Category: Antennas: VHF/UHF+ Omnidirectional: verticals, mobile, etc

eMail Subscription

Registered users are allowed to subscribe to specific review topics and receive eMail notifications when new reviews are posted.
Review Summary For : Ventenna VT-27 2M/440 Dual Band
Reviews: 24MSRP: 102.
Description:
Vent pipe antenna for 2M/440 Dual-Band Antenna (VT-27). Slides over your existing home plumbing vent pipe and is between 19-36" in height and is used for areas that does not like aerial antenna's or for concealment operations.
Product is not in production
More Info: http://www.ventenna.com
# last 180 days Avg. Rating last 180 days Total reviews Avg. overall rating
00244.7
KG4RUL Rating: 2002-05-29
CC&Rs - HAH! Time Owned: 0 to 3 months.
We have Squirrels who think our roof is a freeway so I was dubious about leaving coax lying on my roof. They have been know to chew off phone wire drops in our area. So, I cut off the connector and pulled the coax back through the hole. A little Black RTV sealed up the hole. I put a black ABS cap on the top to seal up the hole. I had a vent stack put in that is actually not connected to anything in the attic. This allows me to attach a coax jumper to the antenna and keep it all within the roofline. There is absolutely no clue that this is not a vent pipe. Performance is good and I can access repeaters that had not been reachable with the same rig attached to my mobile antenna.

A definite good buy!!
KG4RWM Rating: 2002-05-29
Works well Time Owned: 0 to 3 months.
I purchased a Ventenna because I live in a development that does not allow outside antennas.

I purchased the 2 meter/440 MHz dual band model. It is about 36 inches long, and is made of 2 inch black colored PVC pipe. This gives it an outside diameter of 2 1/2 inches. The instructions tell you to slip it over an existing toilet vent pipe, and tighten the set screws. Well, here in south Florida, our toilet vents are called “lead stacks” and mine has an outside diameter of three inches. I have never seen a toilet vent pipe that this Ventenna would fit on without some modification. So, I got a short length of three-inch PVC pipe, and a coupling, and a three inch to two inch bushing to adapt the Ventenna to fit on the three inch PVC. I then slipped the three inch PVC pipe, to which I added some set screws, over the lead stack vent pipe, and tightened the set screws down. I painted the whole thing a dark grey color.

There is a short (about 18-24 inch) pigtail of RG-58 coax cable with an SO-239 connector coming from the side of the Ventenna near the bottom. I connected my coax to that, and ran it to the transceiver.

The Ventenna performs very well, it requires no tuning or cutting. My previous antenna setup was a dual band mag mount antenna sitting on a metal file cabinet in my radio room. The Ventenna is a great improvement over that arrangement. They are also available in single band VHF/UHF models, 220 MHz, and a scanner model.

I would recommend this antenna for anyone who lives in an area where outside antennas are restricted or not allowed.
KC2HOQ Rating: 2001-05-10
Great Ventenna - worked the ISS with it Time Owned: 0 to 3 months.
Used this antenna with an ICOM-746 to work Susan Helms in the ISS on 05/09/2001 at 07:44 EDT on their pass overhead to the west of my location in New Jersey. I was very surprised when Susan came back to my call and reported a "loud and clear". I had been listening on many occasions and had only heard "packet" signals. This time though, she was on the air and had a very good signal (S 5-9).
I've had this Ventenna now for several months and it has worked great. I have a Diamond 2 and 70 cm SWR dual meter hooked up to this and my ICOM. Across the 2-meter band I get no worse than a 1.5:1 reading. Most of the SWR readings in the middle of the band are 1.2:1. On 70 cms the SWR is also very good. I like this Ventenna and recommend it highly.
NH7BG Rating: 2000-09-18
Easy to Set up, Looks deceptive. Time Owned: 0 to 3 months.
Just received it after ordering it from Ham Radio Outlet.
Easy to set up on the roof over existing vent pipe of your home.
Connect your choice of coaxial cable to a female SO-239 connector that runs off a pig tail from the antenna on the outside.
SWR out of box is marginal, with a use of antenna tuner will produce a fairly good match at 50W. Between 5-10W SWR seems good.
Advantage is I live in a neighborhood that prohibits aerial antenna's and from far it just appears to be a long vent pipe.