Manager


Manager - NA4M
Manager Notes

Reviews For: Hy-Gain AV-640 Eight-Band Vertical

Category: Antennas: HF: Verticals; Wire; Loop

eMail Subscription

Registered users are allowed to subscribe to specific review topics and receive eMail notifications when new reviews are posted.
Review Summary For : Hy-Gain AV-640 Eight-Band Vertical
Reviews: 70MSRP: 449.99
Description:
Hy-Gain 8-band Vertical 40/30/20/17/15/12/10/6M
Product is in production
More Info: http://www.hy-gain.com/Product.php?productid=AV-640
# last 180 days Avg. Rating last 180 days Total reviews Avg. overall rating
15704.2
W2SAS Rating: 2023-02-06
Better than I expected! Time Owned: 0 to 3 months.
Just spent 12 hours inside my basement putting this thing together, checking measurements and rechecking, dropping the #6 screws, dropping nuts on the floor and rechecking measurements and torque on all of the pieces. It was great therapy while it was 2 degrees outside. Got a warm day and hung it outside attached to the back of my shed leaving a foot of air-gap between the shingles & the droopy radials. Tied 100 foot of LMR400 on it and powered up the Rig-Expert and thought WOW this is much better than I expected. Here is what I measured at factory settings:


40M SWR is 1.02 @ 7.330 mhz - 5.63 Midband

30M SWR is 1.03 @ 10.174 mhz - 1.4 Midband

20 M SWR is 1.17 @ 14.100 mhz - 1.32 Midband

17M SWR is 1.26 @ 18.200 mhz - 1.99 Midband

15M SWR is 2.0 @ 21.165 mhz - 2.03 Midband

12M SWR is 1.64 @ 25.036 mhz - 1.72 Midband

10M SWR is 1.40 @ 28.570 mhz - 1.49 Midband

6M SWR is 1.05 @ 52.140 mhz -2.98 Midband

Obviously I will drop it and extend the 40 meter section but otherwise the tuner takes care of any small changes needed. Very happy with my compact 8 band vertical.
N4AK Rating: 2022-09-14
A very good vertical without the hassle of ground radials. Time Owned: 0 to 3 months.
This vertical antenna is excellent if you have limited space for radials or simply don't want the hassle of installing them. The SWR can be adjusted below 2.5 to 1 on your favorite operating portion of each band....so your rig's internal tuner can be used! To adjust the SWR initially you will need to raise and lower the antenna several times... so keep this in mind when installing it. All the parts came with my package. Most of my operation so far has been on 40,20 and 17 meters with good results. I suggest you not trim any radials (spokes) initially.....put it up.....take SWR readings....make yourself a chart...then begin adjusting SWR on each band. I am 81 years old and have been on the air since 1957. I did find it convenient to have assistance in raising and lowering the antenna. It was ground mounted at 10 feet using a treated 2 X 2 post and metal articulating bracket. DX Engineering as usual was prompt in shipping. You must have an antenna analyzer to adjust the radials (spokes). I recommend this vertical.
K2QB Rating: 2021-08-31
Great Choice for a Vertical with no Radials Time Owned: 0 to 3 months.
Similar to another review, this antenna replaced an R7 that had been in storage for 11 years and in service for 10. I thought (story for another time)it had given up the ghost so I ordered the AV-640 as a replacement.

I have always had a beam and other antennas such as loops, EFW's etc but before the R7 never a vertical. The R7 surprised the heck out of me as to how well t worked especially on 30 and 40 meters.

Didn't know what to expect from the AV-640 but I have been pleasantly surprised. Assembly was very straight forward as long as you take the time to read the manual over several times to ensure you understand what's being called for. I had no issues with the assembly except as another reviewer stated the mounting base was actually for the AV-680 and a call to Tom at Hy-gain resolved that.

Once up and running all bands resonated exactly where they were set to except 17 and 40 meters. Before taking the antenna down for adjustment I spoke to Tom once again and he indicated that if you set it according to the manual it will resonate quite a bit lower then stated. Not sure why that is or why the manual hasn't been updated to show the correct measurements for those bands.

After having it up for two days the SWR suddenly went infinite on all bands. Again a call to Hy-Gain and Tom who was extremely helpful in offering some testing tips and once I did those he decided I received a bad matching unit. A new unit was received in a couple of days. Once installed I tested the antenna at the base using an analyzer and nothing changed so again a call to Hy-Gain and the ever helpful and patient Tom. After speaking with him I tried another analyzer and lo and behold it worked! It seems that my analyzer decided to go south in the two days I had the antenna up and running. The original SWR issue was a bad connector at my lighting protection so I not only had a connection problem but a bad analyzer as well.

Since having it up and working I can honestly say it meets or exsceeds the performance of the R-7. I operated in the WAEDX CW contest on 40 meters running 100 watts and was asked by several Euro stations for QTC's which tells me I had a solid signal to them.

Overall I would have to say as others have stated, if you are looking for a vertical that does not need radials this is a great option. Mine is sitting about 12 feet above ground and works great on all bands.
WA4SCA Rating: 2020-12-25
Works well, but has some mechanical bugs. Time Owned: more than 12 months.
The antenna performs surprisingly well, and has also weathered some heavy winds. However, I have twice turned on the rig only to find virtually no signals.

The first time, the top aluminum bracket which holds the matching box had fractured at the 90 degree bend. The aluminum was thin and brittle, and could not stand the continuous flexing. I added an aluminum angle bracket for reinforcement, which solved that problem. No repeats in 4+ years.

Update: The angle bracket I installed finally broke. This time, I realized that only one bracket was needed for mechanical support. Accordingly, I replaced the top bracket with a copper strap which has enough "give" to handle the flexing in the wind. The current fix has worked for 5+ years, but just to be prepared, I have a replacement strap available.

The second time, when I was examining it, I heard a buzzing noise from the matching box. Then a small wasp flew out of the drain hole on the bottom! I sprayed a good amount of wasp spray into the unit, and after waiting a bit, took it down and opened it. There were several dead wasps and a nest inside.

I cleaned it out carefully, washed out all the residue, and after drying, it was as good as new. Slightly better actually, as I cleaned up some cold solder joints. (Remember, the is a MFJ in all but name, with all the quality control deficiencies that implies!) To prevent a repeat, I cut two small circles of window screen and glued them over the drain holes inside the box. No new visitors with 6 or 8 legs.

N8XMS Rating: 2020-12-25
I'm pleased with this antenna Time Owned: 0 to 3 months.
I’ve had my HyGain AV-640 up for about two months. It replaced an old Cushcraft R7 that had been in use for 27 years! Overall I am very pleased with this antenna and recommend it for anyone who is considering a multi band, no-radial, vertical antenna. I will break down my review into several categories:

Materials Quality = 3: My antenna came with the 20m capacity hat spokes cut one inch too short. And the hardware for mounting the antenna didn’t match the assembly instructions and caused some considerable confusion at first. (See next category.) There is a little more plastic than I would like to see and I don’t think that it will last as long as my old R7 did, but I am expecting to get some good years from it.

Customer Service = 5: A call to Tom at HyGain resulted in a speedy replacement for those 20m spokes. He also explained that the mounting hardware for the AV-640 has been changed to the same as what is supplied for their AV-680 model, but that the manual has not been updated to reflect that fact. So a quick download of the AV-680 pdf assembly manual cleared up that confusion.

Ease of Assembly = 4: There are a lot of parts to this antenna and carefully following the instructions is important. I also recommend double or even triple checking all of the important measurements. I took my time over several days and didn’t have any problem. My son-in-law gave me about 10 minutes of help to actually get it vertical and on the mast. (My antenna is on the same mast that supported my old R7 and it’s base is about 7 or 8 feet above the ground.)

Performance = 5: It’s certainly not a Yagi at 60 feet but it’s really working well for me. The SWR is good on all bands, except it’s just a little bit high on the CW part of 40m. I could take it down and tweak that but for now I’m just letting the tuner in my rig take care of it. I’ve had QSOs on all the bands from 10-40 and have worked some nice DX as well - all CW at QRP or QRPp power levels. (I don’t have a radio for 6 meters and didn’t even install the stud for that band on the antenna.)
KZ5A Rating: 2020-09-11
Really good DX antenna Time Owned: more than 12 months.
I've owned and used one of these for close to 20 years. i've rebuilt the transformer box twice over the years and replaced washers, clamps, screws, etc. Currently I am setting it up in it's forth and final QTH in Capitan, NM. Its been up for abt 3 months (temporarily??) here at 10 ft above gnd and is working an amazing amount of DX on FT8 with 75 watts from a TS-440.

This is not a NVIS antenna but it is an excellent DX antenna. Contrary to the last MFJ advert I saw for the antenna it is NOT a collection of 1/4 wave verticals in parallel, it is a set of 3/8 wave parallel stubs feed by a 4 to1 transformer (200 ohm), which explains the low angle of radiation.

It is very easy to tune since there is minimal interaction between the tuning of the 8 bands.

i think this is still the best performing most durable multiband vertical on the market, even after all these years. Or really, especially after all these years.

73 Jack KZ5A

ZS6VLT Rating: 2020-09-10
Small footprint with big band coverage. Time Owned: more than 12 months.
I am very Blessed especailly in acquiring this antenna. I found it on a local swop shop form an elderly HAM moving into retirement. The antenna mostly assembled and was delivered for the equivalent of 75 USD in 2017.

Overall the antenna was weathered (aparantly it was on stilts for the last 3 years), fortunatley in South Africa we mainly have sun to worry about which did not seem to have much impact on the appearance or performance.

Given the fact that it was pre-used and tuned for some applications, which seems to have been mainly CW part of every band, and FM portion on 6m.

Even with the AV-640 merely 5m above the ground to comply to local munisipal regulations in Pretoria, the antenna is performing well beyond expectation.

All Bands are either usabe without an antenna tuner or the few that are tuned on the other side of the band easily tunes with the MFJ 939 antenna tuner.

It has been up for more than 2 years and I am very pleased and happy with the performance.

This is my first vertical and my first permanent installed antenna, previously used Diplole, Aplha Military whip and G5RV.

Findings: Maybe this is a general vertical problem but I find the antenna very noisy with regularly experiencing S6 noise compared to a Dipole maybe only S3 noise in direct comparison.

For local operation I was surprised that the vertical has very limited NVIS catecaristics duue to low takeoff angle.

Other than that I am really enjoying DX with the IC7200 at 100w maximum.

Finally I would reccommend this antenna to anyone that are looking for a lekker DX antenna with a small footprint and big band coverage.
VK3XIW Rating: 2018-10-03
Wrong parts Time Owned: 0 to 3 months.
Bought this from a local source here in Australia and when I came to assemble it, the carton was still stapled closed, found that one section of tubing was incorrect so that it would not all fit together. Investigations are under way to solve the problem
N6KP Rating: 2017-10-28
poor instructions Time Owned: 0 to 3 months.
I know this antenna has been on the market for years but has the typical MFJ/hygain problems.
Poor parts count-missing brackets SS washers and some SS screws.
Set it up for SSB and even after following the directions as to length to cut parts, initial testing with MFJ analyzer came up way low in freq. Tried calling hygain many many times and could not get anyone to answer. Finally put a Palstar tuner on it to bring up in frequency. Price is way out of line considering R&D done years ago.
KC5LL Rating: 2016-09-28
Incredible Antenna for the Cash Time Owned: 0 to 3 months.
I read a review on here that seemed pretty positive so I went to my local HRO to see if they had one in stock. They did and I think I was out the door for around $400 or so. Over the next week or so I assembled this thing and there was only one question about some measurements and the factory support came back a day or so after my email to them- After I got the antenna assembled I did a series of tests where I mounted it on top of a 10' pole and ran an antenna analyzer on all of the bands separately. After 3 series of tests I got all bands (targeting voice portions of the band) tuned to 1.7:1 or below. On 20m I think both ends were near or at 2.0:1 but everything else was very acceptable to me. I hooked this thing to a Yaesu FT-897D and it sounded like a live feed into a town hall meeting. Voices came pouring out from everywhere. I have worked 3 contests (very very new at that too) and have have remarkable results from here in North Texas. This antenna sits atop a 36' tip up base so 40m is at or near 60' high. I was going to use this as a transition to a hex beam but with this performance I am not as motivated to make that plunge. Pay real close attention to all of the screws being tight and read that assembly manual over and over until you understand where it is leading you. If you do that you will end up with a product you will feel great about owning. thanks Hy-Gain!